Small_stepper.step(Steps2Take) // direction from the IR signal Irrecv.resume() // receive the next value Serial.println(results.value, HEX) UN Comment to see raw values If (code(&results)) // have we received an IR signal? Small_tSpeed(StepSpeed) // speed from the IR signal Void loop() /*-( LOOP: RUNS CONSTANTLY )-*/ Serial.println("Questions: // Start the receiver Serial.println("Maker Store Camera Slider Stepper IR Receiver Button Decoder") here in the sequence 1-3-2-4 for proper sequencing to Motor Driver In1, In2, In3, In4 and then the pins entered The pin connections need to be 4 pins connected IRrecv irrecv(receiver) // create instance of 'irrecv'ĭecode_results results // create instance of 'decode_results' Int receiver = 7 // pin 1 of IR receiver to Arduino digital pin 7 * Maker Store Camera Slider Stepper IR Receiver Button Decoder Example Software Sketch Upload the Camera Slider sketch to the Uno: Use a small breadboard to make the connections easier.Ħ. Attach the stepper motor, driver board, IR receiver, power supply and Arduino Uno as per the diagram below. It is kept loose to allow for adjustment.Ĭlick on the images to open a larger one in a new window.ĥ. Do not tighten the lock nut on the screw with the eccentric spacers yet. Make sure to use the eccentric spacers on one side of the carriage. Using the 35mm screws (not the 25mm that come with the solid V-Wheels) assemble the carriage as per the drawings below. This will make sure that when you put all the screws and eccentric spacers in they fit without effort.ġ. Here is the Sketchup file for the plates:Īfter the plates are cut/purchased check the holes for the correct sizes by running either a 5mm or 7mm drill bit through. The Maker Store plates are cut from 3mm thick perspex but 3mm aluminum will word just as well. The camera slider plates can be either purchased from Maker Store or you can cut your own using either a CNC router or Laser cutter. The included Arduino sketch allows for the use of the IR remote to control the speed of the carriage.īelow is a list of parts and instructions on how to build the DIY Arduino Controlled Camera Slider. The slider uses a carriage running on a V-Slot rail, a small stepper motor, an Arduino Uno and an infrared remote. In response to demand I have put together a build using parts available from Maker Store that is suitable for a light weight camera such as a GoPro. Many people have asked me if Maker Store has a camera slider kit.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |